This should be no longer than 20 feet from the softener. You will need a drain for the backwashing cycles. You will need a standard outlet that is not controlled by a switch, which can be 50 feet from the softener. Do not put salt in the brine tank until you have put the softener into service and have tested the cycles. The tank with the removable lid is the brine tank (for softener salt or potassium chloride) and is the tank you need to refill occasionally, so make it the more accessible of the two. F) The tanks should be set close to each other. It should dry, protected, level, and non-freezing area (34- 120 deg. When certain there is no more air in the pipes, then turn on electricity to the water heater. Once you are satisfied with the installation, turn on a few hot and cold water faucets and let them run. If you have an electric water heater, we recommend that you turn off the electricity to the water heater while installing the softener. Introducing the Polaris Lab Water Systems Celebrating 32 years providing high quality products and advice.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |